Adapting the "Joe Machine"

[sdantonio]

This may be a totally dumb question, but if I don't ask it I will never know.

My background is totally in wood and I know practically nothing about metals.

Can the typical "Joe" machine be adapted for dealing with ferrous metals... mild steel, maybe some stainless. I realize that this would be more complicated than just throwing a spindle on it and calling it a mill. But what would be involved with the redesign, or would it be easier and safer in the long run to look at a completely different set of plans for the metal machine? And if so, which plans and are they available here?

Thanks

[the__extreme]

Thats a really interesting question. I know that the forces involved in cutting any steel would be considerably (~20x?) higher than for routing wood & plastic. In one of the labs we did, we measured force for turning a large steel round on the lathe. Calibration wasn't precise by any means, but measured force was about 1000N = 100 kg = 220 lb.

I know Andy (Lionclaw) did some aluminum work, which seemed to work well. Like you said, you'd definitely need a different spindle setup to lower the speed and increase the torque, which would inevitably be heavier. With some modification and component repositioning (to balance the added weight balance) I think it would be do-able. The gantry sides would need to be stiffed to compensate for increased side loads when cutting the in Y direction. Gantry tipping may also become a problem when cutting in the X direction. Depending on how much you're taking of with each pass, you could reduce the loads. Coolant issues would definitely arise though since it is MDF (or ply or whatever). But I guess it could be tried...I'm not responsible when your machine soaks up the coolant and doubles in size like one of those 'Just add water and watch it grow!' toys. Without any coolant you would go through a lot of bits/cutters.


Check the result and a video of Andy's aluminum cutting here:
http://www.cnczone.com/forums/showth...=14331&page=18


I'd like to think it was possible, but my instinct tells me it would be better to go with a different design and materials.


- Shawn

[sdantonio]

Shawn,

Thanks, good ideas. if I epoxy laminate the MDF like i was making a wooden boat that should help a lot. I'll have to think about this more. I'll also have to read the dave gingery book on it to get some ideas