servo drivers

[windsor]

I'm in the planning stages of building a cnc router . I like the idea of servos and have looked at the clifton cheap servos . --Next step is the power supply and driver . How many amps would be reqired to use four of these on a gantry design at 30 v ? ---Next question is the servo driver . I came across these and was wondering if anybody had had any experience with them ?
http://www.imsrv.com/deskcnc/servospecs.pdf
At $275 for four it looks like a pretty good deal ?

[len]

I checked out drivers, they look good! I assume you will be using two drivers on the "x" axis
and one each on the "y" & "z" if this is true then you should do well with a 15amp supply with
15-20,000mfd capacitor for filtering.

[pack rat]

You might be aware of it, Clifton motors will need encoders before they can be used. I could not find that price for servo drivers on imsrv. website.

[kong]

If you mean the clifton cheap servo's from this thread, then thay are rated at 20 Amps peak. The driver boards you are looking at are only good for 5Amps. The cheap servos will work well with gecko 320's, and you know you're gonna get the best service if you buy from them.

[imserv]

Originally posted by pack rat You might be aware of it, Clifton motors will need encoders before they can be used. I could not find that price for servo drivers on imsrv. website.

pack rat, the pricing is available at our on-line store at http://www.cadcamcadcam.com

Fred Smith - IMService