home made CNC wire cutter and router - CNCzone.com-The Largest Machinist Community on the net!

geesville · #1 01-25-2004, 06:12 AM

hi all, just thought you might like to have a look at our home made cnc gear,

all MDF and ally

best regards,

micheal j black

geesville · #2 01-25-2004, 06:16 AM

and another, this is our first CNC router and it runs at 46" oer minute, we do use 6mm lead screws but its great, and 4" Zaxis as we use it to route fuselage halves for molding takes about 1.5 to 2 hours to route one half of a fuse.

MJblack

geesville · #3 01-25-2004, 06:20 AM

And another, we have changed the Z axis now fro maximum movement, we were surprised how accurate it truely is!

MJblack.

www.rcelectricflight.com

Bloy2004 · #4 01-25-2004, 07:04 AM

Nice!
Is that a "hot wire cutter" device in the middle of your first pic? Or am I just imagining ....
I'd like to see and read more of this aspect of your shop!

geesville · #5 01-25-2004, 07:09 AM

yeah we make model aircraft kits and cannot live with out it now....we used to do it by hand but..eeeuughh..just isnt repeatable enough for me...or at least im not patient enough! lol

go have a look at our kits and stuff at www.rcelectricflight.com

best regards, mike

ninewgt · #6 02-05-2004, 08:24 PM

Sam

Are you giving up on your big machine ??

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Can you Convert A CNC Router to a CNC Foam Cutter with this Driver?	Sanghera	Xylotex	6	06-18-2005 11:19 AM
CNC Router Taper Machine	hadjcues	DIY-CNC Router Table Machines	8	03-23-2005 05:02 PM
Kit or Already built Balsa/LitePly/Depron CNC cutter?	Xnaron	DIY-CNC Router Table Machines	4	11-22-2004 10:22 PM
Handheld Plasma Cutter with CNC?	Jim Stein	CNC Plasma and Waterjet Machines	5	08-28-2004 09:41 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)