| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| DIY-CNC Router Table Machines Discuss the building of home-made CNC Router tables here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-19-2004, 12:34 AM
| |||
| |||
Hey I was looking on the Camtronics website tonight and saw that they had 692 oz in stepper motors. Now fo the loaded question would it be posible to run these steppers with the xylotex driver in series I see that it would be possible to do it with that driver because the amps are under 2.5 or am I way off base here? It would be nice to be able to start off with that driver and then If I wanted to in the future switch to the geckos. I want to get some good size motors right now instead of buying something that is too weak and I think that for my application the Nema 34 frame is the way to go instead of going with the 23's and then having to make new mounting blocks and couplers. Thanks, Carl  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Open Source Boards Available, Stepper Drivers and Break Out Boards | pminmo | Open Source Controller Boards | 762 | 11-21-2011 10:51 PM |
| Great value stepper drivers | xairflyer | Stepper Motors and Drives | 15 | 05-31-2008 09:14 AM |
| Have existing stepper motors but want to replace control board with integral drivers. | Gerald_D | General Electronics Discussion | 3 | 05-22-2005 09:55 AM |
| stepper drivers | Nilesh | General Electronics Discussion | 3 | 06-22-2004 08:05 PM |
| Possible CHEAP drivers, stepper and/or servo | NeoMoses | General Electronics Discussion | 5 | 03-23-2004 01:45 PM |
| | |
Linear Mode
