10 wire stepper - CNCzone.com-The Largest Machinist Community on the net!

xairflyer · #1 01-04-2004, 07:09 PM

Hi Guys,

I have a 10 wire berger lahr stepper motor 1.4A, 2.3 ohm I have measured it and there is 5 coils.

I am stuck as far as knowing how to connected it.

balsaman · #2 01-04-2004, 08:25 PM

I don't *think* it can be used on a regular unipolar or bipolar drive. I could be wrong, but I am pretty sure it's a whole different animal.

Eric

xairflyer · #3 01-08-2004, 02:19 PM

Have I bought a white elephant ??

10 wire steppers don't seem to be very common.

Stevenpats · #4 01-08-2004, 03:19 PM

Berger Lahr and one other company make 5 phase stepper motors and controllers, but I have seen the controllers on ebay a few times. I have a couple of the motors that came on a 2-axis assembly, I robbed the encoders and bearings from them and they are in my scrap box.
Steven

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
8 wire Stepper motor wiring connection	hornet	Stepper Motors and Drives	7	10-05-2009 10:03 AM
Using Cat 5 cable for stepper motors?	10bulls	General Electronics Discussion	3	04-23-2005 11:24 PM
12 wire stepper	extreme	Stepper Motors and Drives	5	03-24-2005 06:56 PM
How to Wire the Camtronics Stepper motors?	Cold Fusion	General Electronics Discussion	3	05-27-2004 03:15 PM
Correct Stepper Wire ? ?	Mr.Chips	Xylotex	1	05-08-2004 09:44 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)