What about these steppers? - CNCzone.com-The Largest Machinist Community on the net!

blfinche · #1 08-25-2006, 10:32 AM

What do you think about these steppers? STEPPER MOTOR SLO-SYN MOTOR M092-FD-8109 Are they a good buy at $30 bucks?

http://www.electrosales.com/warner/slosyn/m09.htm

Bobby

aggie_67 · #2 08-25-2006, 12:00 PM

Just a newbie myself but the 4.6 amps rule out most DIY drivers.

Madclicker · #3 08-25-2006, 12:06 PM

The 092 has a nice flat torque curve. I'm using a 4 wire version of this with a gecko on my z and get 100+ rapids. This is an 8 wire motor and should go even faster. I think it's a very good choice and buy for a mid size router.

Madclicker · #4 08-25-2006, 12:19 PM

Originally Posted by aggie_67

Just a newbie myself but the 4.6 amps rule out most DIY drivers.

3.25A series and 6.5A parallel.

Madclicker · #5 08-25-2006, 12:35 PM

Are you talking about these?

ebay item

If so, you should consider the shipping. It's $25 to my house and I think that's way too much. I wouldn't buy them.

blfinche · #6 08-25-2006, 01:56 PM

That's the one and the shipping is brutal.

Thanks for the advice.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)