A Big Thank You!

[lgroulx200]

I was down stairs cleaning up my work shop. I piled up my failed attemps at building a CNC router. 12 weekends worth of work.

If it were not for this site, I am not sure I would have kept going.

I read the "silly questions" that I was afraid to ask. Viewed other peoples pictures and read about their successes.

I just want to say thank you.

Larry

[whirlybomber]

dude, you're not giving up on that last one are you?

It looks like you're ready to wire up the motors and start moving it?

[lgroulx200]

Whirlybomber,
I am keeping that one. I am in the process of putting together my CNChobby kit, then install my limit switches and couplers, then start spinning.

Larry

[rippersoft]

And from a burning pile of junk, the CNC Phoenix arose. Taking 3-axis, rollerbearing flight. Don't give up, don't give in.

By the way, how do you like the moving table? Mine is a moving table on U-channel instead of gas pipe. I think the whole machine is a lot stronger since I don't have to push a big gantry around.

[lgroulx200]

rippersoft

My current machine uses a moving table because it was easier to build. But it does make the machine very sturdy.

Larry