DIY CNC Router - CNCzone.com-The Largest Machinist Community on the net!

edmond · #1 02-23-2006, 12:24 AM

I am interested in building a CNC router mainly to cut non ferrous metals with
a table size of about 3 foot by 6 foot.Can anyone help me with plans for the mechanics and the electronics

ger21 · #2 02-23-2006, 07:31 AM

I haven't seen any plans for a machine that large that's capable of cutting metals. The only thing that comes to mind is the data-cut, www.data-cut.com , but I'm not sure if it's strong enough.

edmond · #3 02-23-2006, 11:54 PM

Ok thanks Gerry I had a look at the data cut router website but I am still looking
to build a bigger cnc router that a full sheet of aluminium (1250mm x 2500mm) can fit on.I found a web site about CNC router parts and plans will probably get them there.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)