what type of stepper motor to use - CNCzone.com-The Largest Machinist Community on the net!

08-26-2003, 10:48 PM

landart

*Registered User*

Join Date: Jul 2003

Location: chandler, arizona

Posts: 21

what type of stepper motor to use

permalink

I am in the process of bidding on an small all aluminuim cnc router set up on e-bay. The travel is approx 22inch for the x-axis and 17 inches for the y-axis. I will be using the dremel router on this unit. Can anyone suggest the proper size of stepper motors and controller card that would be more than adequate for this type of machine. Is there any type of table to look at to get me in the ballpark? Any suggestions would be most appreciated..thanks Jim

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Not good for a stepper motor?	FLUTE HEAD	Stepper Motors and Drives	4	12-01-2004 11:31 PM
Help find terminal connector type for this stepper	Konstantin	General Electronics Discussion	3	10-09-2004 01:34 PM
Fun with floppy stepper and driver	Konstantin	General Electronics Discussion	5	03-08-2004 01:18 AM
disassembly of stepper motors	dhprc2	General Electronics Discussion	8	06-25-2003 07:09 PM

All times are GMT -5. The time now is 09:23 AM.