Vacumm Fixture - CNCzone.com-The Largest Machinist Community on the net!

SPEEDRE · #1 11-23-2005, 08:45 PM

Question. I want to build a hold down fixture that uses vacumm suction. Does the suction need to be constant or can it be applied and then once it's held fast can it, the suction be cut off?

cbass · #2 11-23-2005, 10:15 PM

Maybe in theory. In practice it all boils down to how good a seal you can get.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)