newbie needs advice!

[Freedomfab]

hey guys, im new to CNCZONE and cnc in general. i recently purchased an old tecno router. the table and gantry are in good shape but it is running on an ancient computer and the i would like to update everything from the table to the computer. new motors new drives, power supply etc. any body ever done this? if so could any body advise me on a good place to start? thanks in advance!

[DonFrambach]

You could simply buy a retrofit kit. Includes drives, controller, software, and support. Be sure to buy the same sized motors and it should be a simple unbolt, rebolt, and connect wires conversion. A little pricey but you'd be up and running very quickly!

Here's one possibility: CNC Retrofit Kits Overview | Flashcut CNC

[Freedomfab]

thanks for the quick response! going this rout would be simple but as you mentioned $4500.00 is a bit expensive. i'm gonna keep searching to see if i can find a cheaper option.

thanks again!

[DonFrambach]

Surprised it was so expensive. Did you get a quote for their stepper or servo system?

[Freedomfab]

Steppers were a little cheaper, about $3500.00
I talked to techno and they were really helpful. Looks like we may be able to salvage a lot more of the system than we thought.

Thanks again for your help!