| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| DIY-CNC Router Table Machines Discuss the building of home-made CNC Router tables here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-21-2011, 09:09 PM
| |||
| |||
I just finished a fine line automation build and i was doing an archtop guitar today and notice that when I have two axises interpolationg that the movement is very jerky and causes vibrations. is there an adjustment in mach3 or on the g540 that will fix this?  |
|
#2
03-21-2011, 09:15 PM
| ||||
| ||||
| Are you in CV mode or Exact Stop Mode?
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
03-22-2011, 05:41 AM
| |||
| |||
| Ger im not sure i will check when i get off work tonight |
|
#4
03-22-2011, 06:02 AM
| |||
| |||
| Ger its on constant velocity should i change it to exact stop? |
|
#5
03-22-2011, 10:39 AM
| ||||
| ||||
| No, but turn of all the CV options, both on the settings page and in general config, and see if that helps.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
| Sponsored Links |
| |
|
#6
03-22-2011, 04:31 PM
| |||
| |||
| Gerry where is the settings page? I have all of the cv options turned off on the general config |
|
#7
03-22-2011, 04:35 PM
| |||
| |||
| found it |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- jerky movement | Claude Boudreau | BobCad-Cam | 10 | 03-08-2012 06:22 AM |
| Syntec a bit jerky | nash | Chinese Machines | 0 | 08-23-2010 03:01 PM |
| Need Help!- Jerky 3D motion | SScnc | DIY-CNC Router Table Machines | 4 | 05-20-2010 10:15 PM |
| steppers jerky | 300magnum | Automation Technology Products | 10 | 08-17-2008 06:15 PM |
| Jerky Movement | elogicca | Mach Mill | 5 | 11-21-2007 08:19 PM |
| | |
Linear Mode
