Newbie Stepper driver question - CNCzone.com-The Largest Machinist Community on the net!

02-28-2011, 11:18 PM

Join Date: Feb 2011

Location: United States

Posts: 4

Stepper driver question

permalink

Hi, I'm new to cnc, I'm about half way into my cnc build. I bought a 4 axis soc robotics MK4
http://soc-robotics.com/pdfs/MK4%20T...e%20Manual.pdf
and 3 MM160 http://soc-robotics.com/pdfs/MM160%2...al%20Brief.pdf
I see that I can set up limit switches, but can I set up home switches on this driver board? Any input would be welcome.

Thanks,

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Stepper Motor/Driver Question	MillworkMike	DIY-CNC Router Table Machines	12	02-15-2011 04:16 PM
Newbie- Stepper Morphing Driver Question.	boana	Stepper Motors and Drives	0	04-03-2010 02:32 PM
Stepper driver question ?	msnarouz	Stepper Motors and Drives	0	10-29-2006 08:16 AM
Stepper driver/motor question	fzmn321	DIY-CNC Router Table Machines	0	05-03-2006 10:49 PM
Question: Starting a stepper driver?	chuckknigh	Open Source Controller Boards	13	12-14-2004 01:27 AM

All times are GMT -5. The time now is 02:35 AM.