k2 router mount - CNCzone.com-The Largest Machinist Community on the net!

dlpaul · #1 02-21-2011, 06:11 PM

I'm looking for a dimension from the Porter cable 892-690 k2 router mount. The dimension I'm missing is from the center of the mounting holes to where the mount attaches to the Z axis. Thanks

Paul.

CNC Lurker · #2 02-21-2011, 08:52 PM

I don't have that mount, but this router z-plate is designed to hold the K2 router mount. Look at the 10-32 tapped holes on the PDF:
Z Plate [CRP140-01] LINK

dlpaul · #3 02-22-2011, 05:09 PM

Sorry for not making my question clear, I must have spent half an hour trying to figure out how to phrase that so it made sense -- a fail there, I guess. SO, I spent about two minutes drawing the router mount in order to indicate the missing measurement. 2.5''on the attach Jpg is a guess and is the dimension that I would like to know. I found a PDF with all dimension but this one. thanks paul

Woodbutcher-59 · #4 02-22-2011, 06:19 PM

Hi Paul,

I just measured mine and it is 2.5 inches as close as I can see....

HTH

Jeff

dlpaul · #5 02-22-2011, 06:34 PM

Thanks Jeff, it does help, I've been trying to find that measurement for a few days.

Paul

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Better way to mount the router?	napsternova	Hobbycnc (Products)	0	02-01-2010 01:08 PM
Newbie- Where to mount router?	sonicwonder2000	DIY-CNC Router Table Machines	1	09-01-2009 07:34 PM
Looking for CNC Router Mount	GlacialWanderer	Want To Buy...Need help!	1	07-07-2008 01:39 PM
Router Mount	wired	DIY-CNC Router Table Machines	24	09-29-2005 08:08 PM
Need advice on router mount	samualt	DIY-CNC Router Table Machines	3	11-08-2004 09:14 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)