| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| DIY-CNC Router Table Machines Discuss the building of home-made CNC Router tables here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-13-2010, 06:54 AM
| |||
| |||
I am planning to build a CNC router using dual drive (2 motors) on X Axis. Can anyone teach me how to configure the Mach3 to synchronize the 2 motors of the X Axis ? Thank you for your support.  |
|
#2
10-13-2010, 10:46 AM
| ||||
| ||||
| Set the second axis up as the A axis, with the same settings as the X. Then, go to Config>Slaving, and slave the A to X. That's it.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Build Thread- dual stepper setup question . | tony978 | Open Source CNC Machine Designs | 0 | 08-22-2010 10:03 PM |
| Simple, 3 Axes with Dual Drive/Motor (per axis), hardware splitter drive Interface. | kreutz | Stepper Motors and Drives | 3 | 07-03-2008 06:57 PM |
| Dual stepper motor setup | Goose80 | Stepper Motors and Drives | 7 | 12-19-2006 11:46 PM |
| | |
Linear Mode
