| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| DIY-CNC Router Table Machines Discuss the building of home-made CNC Router tables here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-12-2010, 04:36 PM
| ||||
| ||||
I just ordered a Gecko 4 axis drive kit from Keling and got the following message back..... Hi SirWhich motor should I use for my build? I will be ordering 5mm pitch ballscrews and use a G540 with the 48V power supply. The only major differences would be a slight drop of 6 oz-in for the holding torque and the inductance of 2.8 vs. 4.1. Which motor is going to give me the best acceleration? With these small differences does it really matter?
__________________ Http://www.glenspeymillworks.com *Techno LC4896 - 2.2Kw Water Cooled Spindle | *Moving Table Mill from an Omis 3 CMM, 500Lb granite base, Hitachi router, Mach3  |
|
#2
10-12-2010, 05:22 PM
| ||||
| ||||
| The 2.8 inductance motor should give more torque at higher speeds. Other than that, they'll perform similarly.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- Changing Fanuc AC servo driver and motor for a regular VFD and async motor | Bordaco | Servo Motors and Drives | 4 | 09-08-2011 05:41 PM |
| Replacement Motor Brushes For Sherline Mill AC Motor | Lessons | Benchtop Machines | 0 | 07-16-2010 08:34 PM |
| Problems with motor stalling due to motor/lead screw alignment | Bimmerkc1 | DIY-CNC Router Table Machines | 3 | 01-24-2010 06:12 PM |
| New Machine Build- Mach3 , Config, Motor Tuning problem ( FILM OF MOTOR) | MDF_Markazi | Mach Software (ArtSoft software) | 7 | 04-30-2009 02:15 AM |
| replacement motor for PML&Kollmorgen DC Brush Servo Motor | fymroger | Product Announcements & Manufacturer News | 2 | 10-24-2008 03:36 AM |
| | |
Which motor should I use???? 
Linear Mode
