How to you make a stepper motor move? - CNCzone.com-The Largest Machinist Community on the net!

		CNCzone.com-The Largest Machinist Community on the net! > WoodWorking Machines > DIY-CNC Router Table Machines
How to you make a stepper motor move?

DIY-CNC Router Table Machines Discuss the building of home-made CNC Router tables here!

This forum is sponsored by:

08-24-2010, 12:45 AM

Join Date: Jun 2010

Location: usa

Posts: 272

How to you make a stepper motor move?

permalink

I have more than a few old stepper motors sitting around. How do I test them, ie make sure they still move in both directions without hooking the up to a breakout board?

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mach3plasma can't move my servo motor during Mach3Mill can move it ?	nhson104	Mach Plasma / Laser	6	03-14-2011 03:41 PM
Stepper motor move barely!need help	mike3385	Mach Lathe	7	09-27-2010 09:48 AM
Help! Mach 3 Won't Move my Stepper Motor - Emergency Stop Mode	AntonCNC	Machines running Mach Software	7	02-21-2010 11:23 PM
Cant make it move	hugo carradini	General Electronics Discussion	0	10-12-2007 05:50 PM
Rookie question: How to make a stepper motor run using only a battery ?	junior85	Stepper Motors and Drives	14	03-30-2007 06:51 AM

All times are GMT -5. The time now is 06:30 AM.