V groove bearing question - CNCzone.com-The Largest Machinist Community on the net!

06-29-2010, 02:29 PM

Timon Cain Timon Cain is offline

Join Date: Jun 2009

Location: USA

Posts: 7

V groove bearing question

permalink

What size angle iron are people using for V groove bearings?

06-30-2010, 02:15 PM

Timon Cain Timon Cain is offline

Join Date: Jun 2009

Location: USA

Posts: 7

Is 1/8" thick angle iron too small?

07-02-2010, 03:33 PM

Join Date: Feb 2006

Location: USA

Posts: 144

__________________
In the words of the Toolman--If you didn't make it yourself, it's not really yours!
Remember- done beats perfect every time!!

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bearing question	monte55	Mechanical Calculations/Engineering Design	4	05-12-2009 09:40 PM
Linear Bearing question	studysession	DIY-CNC Router Table Machines	6	09-09-2007 11:40 PM
V-Groove Bearing Source needed	widgitmaster	Linear and Rotary Motion	20	03-31-2007 11:42 AM
How much axial force a deep groove ball bearing can take?	interflexo	Mechanical Calculations/Engineering Design	6	08-13-2006 04:06 PM
Ballscrew bearing question	pstockley	Mechanical Calculations/Engineering Design	3	05-16-2006 04:21 PM

All times are GMT -5. The time now is 02:18 AM.