Dowel Pins - CNCzone.com-The Largest Machinist Community on the net!

Ursine · #1 05-26-2005, 06:32 PM

Are the dowel pins called out in the jgro plans steel or wood?

Dave

CNC Darren · #2 05-26-2005, 08:58 PM

I used wooden pins on mine and they worked fine.

Darren

ignatz · #3 05-27-2005, 07:53 AM

I used steel after I read Jgro's build log. I'm pretty sure that he said he used steel pins as well.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
TurboCNC and KCam3 a lost cause?	Davedbq	TurboCNC	17	04-27-2005 03:03 AM
Leveling a CNC Machine	samualt	DIY-CNC Router Table Machines	1	06-06-2004 04:59 PM
The 10 or so, ground pins on the LPT1	thuffner3	General Electronics Discussion	0	02-09-2004 06:37 AM
Dowel Pins	Mr.Chips	General Metalwork Discussion	13	02-01-2004 04:00 PM
Pins setup for gecko G 201	engraver	Mach Software (ArtSoft software)	7	07-23-2003 01:17 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)