| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| DIY-CNC Router Table Machines Discuss the building of home-made CNC Router tables here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-13-2010, 03:38 PM
| |||
| |||
A while back I read a post on this forum that mentioned a company that sells a high power vac motor (similar to a Shop Vac motor) that can be used in groups for a through vacuum panel stock hold down system. Does anyone know who that might have been? I've had no luck trying to search the forum. Thanks, BH Davis  |
|
#2
03-13-2010, 04:19 PM
| ||||
| ||||
|
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
03-16-2010, 06:04 PM
| |||
| |||
| Gerry, Thanks. That took me where I needed to go. Much appreciated. BH Davis |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building a bleed board hold down for sheet stock | bhdavis1cnc | DIY-CNC Router Table Machines | 0 | 12-23-2009 06:55 PM |
| Bleed resistor | appicnc | General Electronics Discussion | 24 | 02-17-2009 07:26 AM |
| bleed resisitor | cueshark | General Electronics Discussion | 17 | 12-06-2007 12:37 PM |
| bleed resistor | bobleecnc | General Electronics Discussion | 11 | 04-30-2007 06:56 PM |
| Bleed down resistors for capacitors | garagefela | General Electronics Discussion | 12 | 07-17-2004 08:40 AM |
| | |
Linear Mode
