Need Help! My router went today on my old DIY table need advise - Page 6


Page 6 of 6 FirstFirst ... 3456
Results 61 to 62 of 62

Thread: My router went today on my old DIY table need advise

  1. #61
    Registered
    Join Date
    Jun 2017
    Posts
    76
    Downloads
    0
    Uploads
    0

    Default

    Quote Originally Posted by ger21 View Post
    Cut the end off a network cable, to connect to your DeskCNC board. I think you only need 1 or 2 of the wires. (PWM and ground maybe?)
    The gentleman I purchased the router from sent me this link.

    http://www.cadcamcadcam.com/boardinterfacepwmto0-10vdc.aspx

    This company sells Desk CNC so they should be a big help if I have questions setting this up & it appears the cables are included. Unless someone's sees an issue with this card.



  2. #62
    Community Moderator ger21's Avatar
    Join Date
    Mar 2003
    Location
    United States
    Posts
    30963
    Downloads
    0
    Uploads
    0

    Default Re: My router went today on my old DIY table need advise

    That would be a better choice, as it's made to work with your DeskCNC board.

    Gerry

    UCCNC 2017 Screenset
    http://www.thecncwoodworker.com/2017.html

    Mach3 2010 Screenset
    http://www.thecncwoodworker.com/2010.html

    JointCAM - CNC Dovetails & Box Joints
    http://www.g-forcecnc.com/jointcam.html

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)


Page 6 of 6 FirstFirst ... 3456

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

My router went today on my old DIY table need advise
My router went today on my old DIY table need advise