Reply with QuoteMy best guess - some kind of wiring or shielding issue.
What's wrong with my setup?
Can you tell what is the problem by looking at the video here
I dont know what cause he motors "jump" every about 3 second. I've tried it with different stepper (Nema 17) and it got the same problem
the setup: Gecko G540, KL23H2100-35-4B stepper motors, 48v 12.5A PSU.
Thanks so much
Similar Threads:
- Need Help!- wrong ATC arm position-wrong magazine mill position on mori seiki NV4000 DCG
- Need Help!- Visual Studio 2015/2012 Template setup for NX10.0 & Custom folder setup
- Need Help!- kia superturn 21 yasnac J50L tool setup and part orgin setup thx
- Looking to buy my first CNC setup. Thoughts on this Partner III / Cent IV setup?
- Where am I going wrong with ports and pins setup?
Re: What's wrong with my setup?
My best guess - some kind of wiring or shielding issue.
Re: What's wrong with my setup?
Run Drivertest.exe in the Mach3 folder and see if you see a spike when you hear the thump.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
