I made a 4x8 bought nema 34 1600 oz stepper motors kit replaced with stepper with nema 23 320 oz used the drivers form kit the bigger motors gave me so much problems
Hello everyone,
New to this whole CNC thing, but I am excited to get my build underway. I am building a 4x4 unit. I am not sure of what electronics kit to purchase. Was looking at CRP DIY kit, but I am wondering if there are better options available. A little unsure about the Longs kits on ebay,(support, wiring schematics, etc)
Any assistance would be greatly appreciated. Also If anyone has a clear wiring schematic to share that would be awesome!!!
Thanks
Similar Threads:
I made a 4x8 bought nema 34 1600 oz stepper motors kit replaced with stepper with nema 23 320 oz used the drivers form kit the bigger motors gave me so much problems
I bought the Longs motors 1600 OZ Inch fit from ebay and run them with the planet cnc software and driver board. And it works flawlessly. Have never lost a step yet.
Artistic 3D Relief Work for CNC http://www.cncproductionwork.com