I seen this thing on Reddit, a CNC Machine that rests on top of a stack of plywood.
Impulsive Furnishing Unit ? Frame Moooi Award winner « Christian Fiebig
My CNC Router Build - http://tinyurl.com/c3vs3ca
Looks interesting. It may be a bit flexy in mid span though.
CarveOne
http://www.carveonecncwoodcraft.com
Nice, I was thinking about something like that just yesterday.
Wood neophyte.
Me too! And this is much classier than he styrofoam manniquin head that I was going to start with. Thanks!
Paul Rowntree
Vectric Gadgets, WarpDriver, StandingWave and Topo available at PaulRowntree.weebly.com
I cut the pocket in the base with a .125" endmill and went a .25" deep for you guys who are going to cut one.
My CNC Router Build - http://tinyurl.com/c3vs3ca
I just got a Galaxy S4 phone and now I need that cellphone recliner file of yours.
CarveOne
http://www.carveonecncwoodcraft.com
work work work..
http://www.cnczone.com/forums/diy-cnc-router-table-machines/140832-cnc-software.html
A number plate for a house we just built. I might try and paint the cuts white.
My CNC Router Build - http://tinyurl.com/c3vs3ca
Something that has worked well for me is to apply shelf paper before vcarving. Then paint and pull off the paper after paint has started to dry. Painting only takes minutes and neatness does not count.
Not sure how it will work on a coarse grain oak. Also having a good sharp cutter helps.
Sent from my iPad using Tapatalk HD
Looks great quite a difference from the two.
http://www.cnczone.com/forums/diy-cnc-router-table-machines/140832-cnc-software.html
Thanks for the tip. Worked nicely...
Inspiring Thought for the Day:
Some people are like slinkies ... Not really good for anything....but they still bring a smile to your face when you push them down a flight of stairs.
What type of shelf paper do you use? Seems like all I can find is non-adhesive.
I found some: ebay
My CNC Router Build - http://tinyurl.com/c3vs3ca
I use contact brand Home Depot had it, I think most targets, walmarts also carry same brand.
Sent from my iPad using Tapatalk HD
would there be a problem using standard masking tape or painters tape for this?
What I have heard is it does not cut well. A gummy mess seems to be the comment I remember.
I have had .5mm square features cut and mask using shelf paper. Also much easier to cover a wide area.