Looking for Microscribe Utility software - CNCzone.com-The Largest Machinist Community on the net!

shadowless · #1 10-23-2009, 12:42 PM

Hi,
Just got a 2nd microscribe 3dx, but the immersion site not longer distribute this free software.

Does any of you have it, can you send it to me.

Also looking for irix version driver if you have it.

Thanks

JAMMAN · #2 11-23-2009, 11:20 AM

I have it, was hard to find though. About 100 sites describe it but no downloads. Supposed to be free from Immersion, I saw one site selling it for $300!

E-mail me jim@ultrabb.com

Jim

MFS · #3 11-24-2009, 02:10 AM

Originally Posted by shadowless

Hi,
Just got a 2nd microscribe 3dx, but the immersion site not longer distribute this free software.
Does any of you have it, can you send it to me.
Also looking for irix version driver if you have it.
Thanks

Slightly offtop... May be it should be interesting to try Rhino3D? As for me - the best soft for Mscribe. Not free but unexpensive and exellent funcionality.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
microscribe tutorials	timmydabull	Digitizing and Laser Digitizing	0	10-01-2008 10:34 PM
Connecting to Microscribe 3dx	robinsoncr	Digitizing and Laser Digitizing	4	03-03-2007 01:26 PM
Utility blades	quadbob	General Metalwork Discussion	3	09-09-2006 05:40 PM
Need a Utility	grumpy74	FeatureCAM CAD/CAM	2	03-11-2006 09:56 AM
a little freeware utility	eriskouma	General CAM Discussion	1	11-17-2003 09:39 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)