| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Diemaking and Diecutting Discuss Diemaking and Diecutting here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-10-2009, 12:47 PM
| |||
| |||
| Where to find speed and feed information I am a new cnc programmer, we are cutting coining dies mostly using half round conical carbide tools. I want to make sure we are using the correct feeds and speeds, some of the numbers we have are 10 to 15 years old and we get a lot of tool wear and broken tools, also have to do a lot of clean up. I have checked with the manufacturer we get our cutting tools from and they basically told me to get lost. I have found quite a few feed and speed calculators on the web but I don't have the numbers I need to plug in, specifically feed/tooth. Does anyone know of any resource I could get generic rates or starting points from? Thank you.    |
|
#2
08-10-2009, 12:50 PM
| ||||
| ||||
| If you P.M. me a email address I can send one. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I have not been able to find information on this automatic zero/ height method | seanreit | Benchtop Machines | 2 | 06-29-2011 03:17 PM |
| Need Help!- Can't find information on Panasonic servo motor | vova | Servo Motors and Drives | 0 | 12-22-2008 06:26 AM |
| speed & feed | kal_pesh | Mastercam | 1 | 07-21-2008 07:56 PM |
| RPM/Feed Speed 4 Ali? | bigz1 | Engraving Machines | 0 | 05-20-2007 06:14 PM |
| anyone know where i can find information on an allen bradley vfd! | CATCH22 | Phase Converters and VFD | 5 | 10-11-2006 10:28 PM |
| | |
Linear Mode
