28xx Die Set - CNCzone.com-The Largest Machinist Community on the net!

gbowne1 · #1 08-14-2006, 02:39 PM

I need to make and/or have made a die set that holds 28xx punches and dies made by CE Tooling in a single station setup. They are the same type used in WA Whitney presses.

Both the punch and die holders must be indexable to 1 or 5° increments throughout 360°.

My die space is 2-1/2ft L-R and 1-1/2ft F-B.

I have a DWG/DXF of a die set that would be good to use as the base platform of the design.

Gregory Bowne
Seattle, WA
gbowne1@yahoo.com

scubanick · #2 08-16-2006, 09:40 AM

upload your drawings

gbowne1 · #3 08-16-2006, 09:15 PM

Drawings coming real soon.. have to update it as there is 3 minor changes that have to be done yet.

Greg

gbowne1 · #4 08-16-2006, 09:21 PM

Drawings coming real soon.. have to update it as there is 3 minor changes that have to be done yet.

Greg

Reytek · #5 03-17-2007, 02:20 AM

Is anybody here have experience in Semicon Tooling Industry?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)