| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| DeskCNC Controller Board Discuss DeskCNC Controller Boards and the software that controls it here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-02-2007, 03:12 AM
| |||
| |||
Hi, yesterday I started testing a setup with DeskCNC 2nd. generation controller and HobbyCNC Pro 3-axes controller. Have the HobbyCNC 305OZ/in steppers for all tree axes. Does anyone have the same setup? I need to set the acceleration Ramp for the system...    |
|
#2
06-02-2007, 02:33 PM
| |||
| |||
Hi maycom, The acceleration settings are done mostly by trial and error, it is also possible to use a spread sheet to calculate the .acc file which will allow you to modify the profile to your hearts content. Just save as a text file and then load it under the Acc. settings menu. Regards, Greg www.cncdirect.co.za |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DeskCNC controller output current? | kolokithas | DeskCNC Controller Board | 5 | 09-26-2006 07:10 PM |
| Deskcnc users, what CAM software are you using with this controller? | Idle hands | DeskCNC Controller Board | 4 | 05-06-2006 02:00 PM |
| DeskCNC Controller and Xylotex | WarrenW | Carken Products (Deskam, DeskCNC etc) | 0 | 12-30-2005 01:06 PM |
| DeskCNC Controller/driver | rogerbureau | DeskCNC Controller Board | 0 | 01-18-2005 03:30 AM |
| 2nd generation DeskCNC controller now shipping | imserv | Product Announcements & Manufacturer News | 13 | 10-01-2004 07:22 AM |
| | |
Linear Mode
