DeskCNC Software Probs

[TOTALLYRC]

Near the end under the Mcodes. Page 15 and 16





http://www.imsrv.com/deskcnc/DeskCNC%20G-code.pdf


Mike

[HobbyCAD]

Mike,

Thanks for the reply, I suppose done in good faith, but really, I have read the manual. The manual is seemingly wrong ..........

Commands M90 to M95 do not work, or at least, if I run a simulation, or enter the command via the MDI box, neither of the 3 Aux buttons grey out. Manual selection of the buttons do grey them out. I'll open up my control box today, and stick a multimeter on the DeskCNC card connector, to check if the output toggles. Maybe the MMI interface is incorrect. Maybe the Aux functions are not software selectable anymore, only manually.

Thanks anyway, it was good to get some reply.

Any idea how to contact Fred? He should know best.

[TOTALLYRC]

You should be able to contact him via his website. im service.

Let me know if you get it figured out as I could go out and try mine if need be. I was not going to be running it for a couple of days but I can check if need be.

On my laptop without the controller I am getting the same thing as you are. Strange.

You could always contact the deskcnc guys direct.

Mike