Results 1 to 2 of 2

Thread: deskcnc

  1. 01-02-2006, 02:52 PM #1
    natchez
    natchez is offline
    Registered
    Join Date
    Mar 2004
    Location
    ms
    Posts
    44
    Downloads
    0
    Uploads
    0

    deskcnc

    can deskcnc servo drives be used without the controller

  3. 01-02-2006, 03:57 PM #2
    ger21
    ger21 is offline
    Community Moderator
    Sponsor
    ger21's Avatar
    Join Date
    Mar 2003
    Location
    Shelby Twp, MI....USA
    Posts
    22211
    Downloads
    0
    Uploads
    0
    This one has a parallel port connection, and says it takes step and direction, so I'd say yes. http://www.cadcamcadcam.com/index.as...ROD&ProdID=116
    Gerry

    Mach3 2010 Screenset
    http://home.comcast.net/~cncwoodworker/2010.html

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)

« Looking For The Best Sherline Cnc Kit | feedrate oddity »

Posting Permissions



About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.