Newbie stepper drive A3979


Results 1 to 2 of 2

Thread: stepper drive A3979

  1. #1
    Registered
    Join Date
    Dec 2016
    Location
    United States
    Posts
    11
    Downloads
    0
    Uploads
    0

    Default stepper drive A3979

    Question: is there anyway to use the outputs to the motors from the A3979s to drive an additional higher output h-bridge. My controller works well, it's just under powered. I'm thinking of it as a preamp. All the signal shapes are correct, so just amplify them? Power these new h-bridges with the new 48v as well and voila I can drive bigger motors

    Similar Threads:


  2. #2
    Member
    Join Date
    Oct 2016
    Location
    United States
    Posts
    29
    Downloads
    1
    Uploads
    0

    Default Re: stepper drive A3979

    Any way? sure but the circuitry would be more complicated than using a h bridge driver chip to directly drive the h bridge of your choice



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

stepper drive A3979

stepper drive A3979