- Need Help!- PnP Proximity Sensor and The TB6600 Controller
-
Registered
PnP Proximity Sensor and The TB6600 Controller
Hi everyone,
I have a 4 axis TB6600 controller
After configuring the Mach3 , I'm now able to control them ,
but I'm little bit struggling on connecting PnP sensors (proximity sensors) on the Controller and make the right configuration in the Mach3
I'm using this PnP model :
here is how its labeled :
I've connected the sensor with the controller Board as below
Blue wire on the Gnd , Brown on 5v , and the Black one on IN1 (or Blue wire on the 5v, Brown on Gnd , and the Black one on IN1) -> the sensor works fine in both of connections !! (red light turns on every time I put a peace of metal near to the sensor)
now I've tried to see what happened in the Mach3 when the red light turns on , but nothing happened
here is my configuration on the Mach3 :
I've followed this tutorial on youtube (
), which allow us to detect the right pins to use automatically , but nothing changed
can anyone help me on this (is the problem in the wiring side or config side ?)
Similar Threads:
-
- Need Help!- PnP Proximity Sensor and The TB6600 Controller
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules