Heidenhain TNC 426 - Parameter / PLC - CNCzone.com-The Largest Machinist Community on the net!

rajappa · #1 06-05-2007, 10:25 AM

Can anybody give how to view machine parameters and PLC programs in Heidenhain TNC 426 control used in Deckel Maho machines ?

kklaver · #2 06-06-2007, 12:04 AM

[Prog Edit] Key
[MOD] key
Make sure you have a program called up in the [Prog Edit] screen
General Use Parameters: 123
Machine Parameters: 95148
PLC: 807667

rajappa · #3 06-06-2007, 09:40 AM

Thanks for your post.

radhakrishnan · #4 10-15-2011, 03:43 AM

Dear all

Please advice how to adjust the backlash in heidenhain TNC 426 controller.
also give the parameter for adjusting the backlash.

Thanks and regards,
A.radhakrishnan

km8137 · #5 11-03-2011, 10:49 AM

how do i re-load the software to a heidenhain 426 controller? i am having problems with the controller ereasing the program as it is running the program. i was told to re-load the soft ware for this controller. can anyone help with this. Thanks km8137

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
parameter list 3tc	R.thayer	Fanuc	8	09-17-2011 03:12 PM
0TC parameter for more memory?	jani	Fanuc	32	01-16-2010 05:44 PM
Rapid to (# set by Parameter) What's yours?	Scott_bob	G-Code Programing	8	07-13-2009 08:05 AM
parameter 64	swartling	Haas Mills	0	02-20-2007 05:57 PM
Parameter changes	jorgehrr	G-Code Programing	9	02-15-2007 09:06 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)