Need Help! DMU-50 Evo Tool Change Recovery Procedure?


Results 1 to 2 of 2

Thread: DMU-50 Evo Tool Change Recovery Procedure?

  1. #1
    Registered
    Join Date
    Apr 2008
    Location
    U.S.
    Posts
    24
    Downloads
    0
    Uploads
    0

    Default DMU-50 Evo Tool Change Recovery Procedure?

    Hi folks,

    We are slowly bringing the DMU-50 online, last night during a tool change something doesn't sound right, and we hit the e-stop. Now I can't figure out how to get out of it. The two "flap" (rotating door) of the tool magazine is open, spindle is on top of tool pocket #2, and I can't get anything to move.

    I believe there is a magic switch inside the cabinet that I have to flip, which turns on a hidden tool-changer control screen on the controller, that allows me to manually move the spindle away and override/close the flap door. Does any of that rings a bell? The controller is a Heindenhain Millplus running software version v500.

    Thanks!!



    Wallace

    Similar Threads:


  2. #2
    Registered
    Join Date
    Apr 2008
    Location
    U.S.
    Posts
    24
    Downloads
    0
    Uploads
    0

    Default Re: DMU-50 Evo Tool Change Recovery Procedure?

    1. Go to the "IO" screen (one of the soft keys on the bottom)
    2. Type in password 78900000 and then "Enter" (password will show up as "********")
    3. Right side soft-key changes to diagnostic functions
    4. Select Tool Changer
    5. Select Flap 1 Close
    6. Key in "0" and then "Enter" to exit diagnostic screen
    7. Back to chip-making



    Wallace



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

DMU-50 Evo Tool Change Recovery Procedure?

DMU-50 Evo Tool Change Recovery Procedure?