Need Help! PUMA 240 M - CNCzone.com-The Largest Machinist Community on the net!

turnn · #1 12-03-2009, 11:02 AM

Headstock and tailstock are not aligned. Tailstock is out .005
which do I align? I think the headstock. Manual not much help. Left a message with service guys. Any thoughts on it.Thanks

CHAD LAWSON · #2 12-08-2009, 07:26 PM

sweep the top and face of each spindle and see which is out both are not hard to align once the covers are removed and specialty tools are built. the best way is to take the chucks off and bolt a precision bar and run the top and side of the bar over a longer distance to really see which is out and trully how bad. it also makes it easier to bring them back in as in four inches of a chuck can be decieving as to how far you are out. but run a two foot bar and see what it shows

turnn · #3 12-09-2009, 12:36 PM

Thanks. I finally got it.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
'97 Puma 200a help	alphaorange	Daewoo/Doosan	3	02-23-2010 10:10 AM
NEED HELP WITH PUMA 200	CNCBEN	Daewoo/Doosan	2	09-16-2009 11:52 AM
Puma	M-man	Daewoo/Doosan	1	05-13-2008 10:25 PM
Need Help!- Puma 4oo manual	Vaibhav.Shelke	Daewoo/Doosan	0	03-26-2008 03:55 AM
Puma & Procomm	ademir	Daewoo/Doosan	4	11-28-2006 02:57 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)