3rd axis turret need grid Shift ! but how ? - CNCzone.com-The Largest Machinist Community on the net!

mte.jalal · #1 08-28-2009, 04:06 AM

Dear friends

I have faced a problem with turret in fact after I started the machine for first time evrything is ok unless the turret position it's about 15 degrees different from original position.

Does anyone know about this problem.

As we have come to conclusion Grid Shift Maybe effective but we don't know how to it.
in fact in Fanuc manuals there was nothing about this point!

MAchine model is : DOOSAN DOTURN 310

Thanks in advance.

Jalal

Al_The_Man · #2 08-28-2009, 09:17 AM

What Fanuc controller?
Al.

mte.jalal · #3 08-28-2009, 10:02 AM

hi.

Thanks for your comment.

the control is Fanuc O-T

Thanks

Jalal

Al_The_Man · #4 08-28-2009, 11:38 AM

For the 0T I show the first four axis are 508-511 axis 5 & 6 are 7508 - 7509.
Axis 7 & 8 are 641 - 642.
I am not sure which applies to the C, I would imagine 510?
Al.

mte.jalal · #5 08-28-2009, 12:38 PM

Al_The_Man

I will try and let you know the result.

thanks,

Jalal

mte.jalal · #6 09-02-2009, 11:26 AM

Congratulations

510 did it

Thanks for your nice help.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Grid shift or X datum move.	honk	Daewoo/Doosan	1	04-15-2009 01:21 AM
Need Help!- Axis shift during machining	zeeshan.insight	LinuxCNC (formerly EMC2)	7	03-19-2009 03:26 PM
Problem- c axis work shift	Atlas_Too	Fanuc	3	10-13-2008 01:14 PM
Setting Z axis with G92 work shift	venomgrrrl	Fanuc	12	12-03-2007 12:02 PM
Grid Shift	scuba	General Metal Working Machines	1	10-13-2004 04:50 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)