Daewoo Puma 700M W/Fanuc 21i-TB

[skeeterzx210]

Need help!! I have a Daewoo Puma 700M W/Fanuc 21i-TB control.I need a post processor or some help editing the Mastercam X MPLFAN.pst. I've changed all the m-codes,but I cant find where to remove the decimal point for the Q value. Thanks for any help.

[g-codeguy]

Not at work so I can't tell you exactly what to change, but maybe I can tomorrow if someone hasn't already pointed you in the right direction. Look at the fs2 section to find out which number is set up for no decimal point and leading 0's omitted. Then change the Q output to that one. There may be more than one Q listed so you will need to find which one needs to be changed. Sorry for being so vague, but thought maybe it might be enough to get you looking in the right area if you want it solved tonight.

EDIT: Q is used in the G71/G72 turning/boring/facing cycles and in the G76 thread cycle. Pretty sure the Q is defined in 2 places.
Oops, not in the G72 cycle!

[skeeterzx210]

Thanks,That gives me somewhere to start looking.

[skeeterzx210]

Thanks g-codeguy, I think that got it!!!

[g-codeguy]

Thanks g-codeguy, I think that got it!!!

You're good. And you're welcome. Glad I could point you in the right direction.