If you have a G-code program that is 3D made up of line movements

G01 X Y Z
G01 X Y Z
G01 X Y Z
G01 X Y Z
G01 X Y Z
G01 X Y Z
G01 X Y Z


Vs.

Have a G-code program made up of Arc movements G18 /G19

G19 G02 Y.4352 Z-.5004 J.362 K-.7885
N13 G01 X-.8 Y.5996
N14 G03 Y-.5996 Z-.5003 J-.5996 K-.7488
N15 G01 X-.7 Y-.7139
N16 G02 Y.7139 Z-.5004 J.7138 K-.7493
N17 G01 X-.6 Y.7997 Z-.5004
N18 G03 Y-.7997 Z-.5004 J-.7997 K-.7494
N19 G01 X-.5 Y-.8659
N20 G02 Y.8659 Z-.5004 J.8659 K-.7487
N21 G01 X-.4 Y.9162
N22 G03 Y-.9162 Z-.5004 J-.9162 K-.7485
N23 G01 X-.3 Y-.9536
N24 G02 Y.9536 Z-.5004 J.9536 K-.7491
N25 G01 X-.2 Y.9795
N26 G03 Y-.9795 Z-.5004 J-.9795 K-.749


Is the run time going to be the same for the two programs?


From what I understand the Doosan machines have good block processing and look ahead with the fanuc 21 i controller.

So wouldn't the jobs run at the same speed?

Any help of this would be great.