DAEWOO PUMA 10 W/FANUC 3-T

[wes4540]

Hello everyone, let me just say first off that I this is a great site with a lot of helpful people & information,I hope in the future I am able to help provide solutions to someones problem.

OK, I just purchased my 1st cnc lathe,and I am having problems getting the hydraulics up. I am getting an alarm 02 vrdy off,I am able to reset the alarm for approx.5-10 sec. then it pops back up.I have tried holding the alarm reset button while pushing machine ready and nothing. The lathe sat for about a year with no power and after reading the post's here I am afriad it may have lost its parameters.(I have replaced the battries)It is not near a overtravel on either axis. Would that alarm not allow the hydraulic system to come up? Any help or advice is greatly appreciated.

thanks,Wes

[MysticMonkey]

v-ready alarm is indicative of a e-stop failure or
disabling the drive as a safety feature for example if the door was open in auto mode

personally i would check the e-stop circuit and any associated relays and the door interlock.

these machines will have mechanical torque limiters on the axis so when the hydraulics are powered up shake the x & z axis with the handwheel

[yours_prabhat]

Hello everyone, let me just say first off that I this is a great site with a lot of helpful people & information,I hope in the future I am able to help provide solutions to someones problem.

OK, I just purchased my 1st cnc lathe,and I am having problems getting the hydraulics up. I am getting an alarm 02 vrdy off,I am able to reset the alarm for approx.5-10 sec. then it pops back up.I have tried holding the alarm reset button while pushing machine ready and nothing. The lathe sat for about a year with no power and after reading the post's here I am afriad it may have lost its parameters.(I have replaced the battries)It is not near a overtravel on either axis. Would that alarm not allow the hydraulic system to come up? Any help or advice is greatly appreciated.

thanks,Wes

please send more detail to me on prabhatmishra@mail.com or call on +91-9430737981