Puma2500Y live tool

[phx]

Hello
i have a puma 2500Y with 18itb.

how can i use Mainspindel and Live Tool together?

thx

phx

[dcoupar]

This may be what you're looking for.

[phx]

Originally Posted by dcoupar This may be what you're looking for.

thanks for helping dcoupar,

maybee my question was wrong. english is not my motherlanguage.

what i want is mainspindel is running, and a rotary tool is running.

regards
phx

[dcoupar]

My apologies. I sent the wrong one. I have to find the one for Main/Live simultaneous.

[dcoupar]

This is from Doosan:

This is how live tool spindle rotation and main spindle rotation can be executed, simultaneously:
1. Start the live tool.
2. Command M206
3. Start the main spindle.

M5;
G97 S--- M33 or M34;
M206 (Spindle Rotation Release, Two Spindle Control)
G97 S--- M3 or M4;

Note: Operation as shown above is possible in AUTO-mode only. Once both of the spindles are running and you switch to manual mode, both spindles will stop.

[phx]

Originally Posted by dcoupar This is from Doosan: This is how live tool spindle rotation and main spindle rotation can be executed, simultaneously: 1. Start the live tool. 2. Command M206 3. Start the main spindle. M5; G97 S--- M33 or M34; M206 (Spindle Rotation Release, Two Spindle Control) G97 S--- M3 or M4; Note: Operation as shown above is possible in AUTO-mode only. Once both of the spindles are running and you switch to manual mode, both spindles will stop.

This works fine, thank you.
and it is working in MDI Mode too.

regards phx