orient of livetool - CNCzone.com-The Largest Machinist Community on the net!

M-man · #1 11-24-2007, 10:21 AM

Is there a way to launch the livetool orient that the machine does before changing tool from a program, just like a spindelorient, but it is on the live tool? I know that it is possible to switch K-relay to get this done just buy pressing the jog button,. I were thinking of a typical arbor operation, and then move tool to clearence in the dia, befor moving it out of the hole.. Any ides anyone?..

dcoupar · #2 11-24-2007, 10:47 AM

If I'm not mistaken, the live tool always stops at the same orientation with M35.

M-man · #3 11-25-2007, 12:09 AM

mabe it does, checking it out on monday.

cncjcl · #4 11-28-2007, 09:06 PM

Yep m35. And if your luck enough to have a twin turret lower is m135.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Hurco MD1 spindle orient	caleb505	HURCO	1	11-24-2007 07:14 PM
spindle orient	nitemare	Daewoo/Doosan	11	06-06-2007 08:38 AM
how do you orient spindle in program (fanuc 18m)	rubino2112	Fanuc	2	01-24-2007 11:56 AM
Spindle orient and A axis smoothing	1ctoolfool	Haas Mills	9	11-22-2006 10:38 PM
Spindle will not orient at tool change	chipsahoy	Fadal	4	07-16-2006 08:39 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)