Lynx 200 Lathe - Fanuc 21-T, how to machine lock??

[Darc]

The machine panel has the machine lock light, but it doesn't have a switch to enable the machine lock, any idea how to lock the machine so I can test programs?
Also how do I use the probe on this machine? Obviously it's got the probe up/down and also the tool measure button, I'm just not sure whether I'm meant to touch the probe with the tool and then press tool measure (which I don't think because that's no different than touching the face of the job and pressing measure)??
Thanks
Darc

[Tim S]

To lock the machine - Enter M17 in MDI mode and hit cycle start.

To unlock the machine - Enter M18 in MDI mode and hit cycle start.

When you touch the tool onto the probe, the offset is automatically set into the registry for you. The measure button is used when setting your Work Offsets.

[Darc]

Thanks Tim S, I'll give that a go.

[Darc]

Beautiful, it worked a treat. Thanks.
Also on another note how do I copy the program, in the manual it mentions to use the [EX-EDT], this machine doesn't have the soft key to suit, our vmc and other lathe has this button, do I need to enable this in the settings?
I just noticed the manual is for a Fanuc Series 21-TB & Fanuc Series 210-TB. Our machine is a Fanuc Series 21-T.
Thanks.

[Green Button]

Its again those option parameters.

Fanuc 18 (should be same):
9936 bit 7 extended edit

Parameter write enable and chang parameter.

PLEASE TAKE BACKUP COPY OF YOUR PARAMETERS BEFORE CHANGE !

[Darc]

Hi Green Button,
I changed it to write enable and then searched for 9936, it then brought up the first line of parameters 0000.
If I have the correct parameter should the 9936 show up where I used the BOLD font? If so the numbers don't go that high.
I've attached all the available screens in the settings page.
Any idea which one I change to get the extended edit?

[Green Button]

Screen looks very familiar. I think that you havent found parameter section.
Try to press "SYSTEM" on keyboard then <PARAM> on soft keys.
Should be found there.

[Darc]

Yep, I'm an idiot..............
I fount the screen you mentioned, I changed it to write enable (see pic), then I went to the SETTING, PARAMETER screen, is the field I've got highlighted the one I need to change, if so, it won't change when I press [1 ON], or 1 then INPUT.
I must be doing something wrong?? Any ideas??

[Green Button]

There must be some other parameter which enables this i think....
When "parameter write enable" was on and you try to change bit...are you sure that machine was in MDi mode & protect key open...if so, there must be another parameter (dont know it yet)

[klisan]

I am having the same problem with a '99 Takisawa EX-108 w/ Fanuc 21i-T (model A). The [EX-EDT] soft key is not available. Is there a parameter that needs to be changed for the [EX-EDT] soft key to appear?

Thank You in advance!

[cnc-king]

if i remember correctly the 9000 series parameters are the option parameters and you cannot change them by just turning the PWE on