Fanuc OT alarms

[Al_The_Man]

Upload failed.try again
Al

[cncmike92]

Originally Posted by Al_The_Man Look here and I sent you a PM. Al.

Thanks again Al, for all your help. Ive sent you a pm!

[drthilina]

Im having a FANUC 6M-B system, and after loading the parameters I'm getting the alarm
417 X SERVO
do you think this is some thing to do with the parameters, if so how can i over come it
Thanks if you can help me anyway!!!

[drthilina]

I have the Fanuc 6L servo motor for X-axis, since i'm getting the alarm 417 which is for X servo digital parameters, do you guys know the correct parameters?
Thank you for your help

[erwin1958]

Originally Posted by cncmike92 Ok the alarms all are cleared. Still having a issue with parameters though. Whatever speed value I input actually triples on the monitor. EG: G97 S500 MO3 actually runs 1500. If anyone has the answer for this it would be helpful. What would really be nice is if someone has the parameter book for this OT-C control on the computer in *.pdf format and would be willing to share it. Thanks for all the help so far.

You must put a "0" in front of the 500. G97 S0500

[fv74]

I have a Puma 10S with an OT control. I am getting an 02 alarm when I try to power up the machine. The hydraulic pump will come on when I depress the Machine Ready button, but it goes off when I release the button. The machine recently ran low on way lube, but I have refilled the reservoir. What else should I look for?

Thanks, Dave