| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Daewoo/Doosan Discuss Daewoo/Doosan machines here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-10-2005, 06:49 PM
| |||
| |||
| G68 angle rotation I am working with a DMV320 mill. The pallet fixture is was not fabricated exactly perfect so I have to place a G68 angle rotation. I have to rotate the coordinates on the XY plane appox. 8.25 degrees clockwise. I've never done this before and was wondering if I might get some advise. Thanks alot.    |
|
#2
09-10-2005, 08:38 PM
| ||||
| ||||
| I am not sure if it the same for Daewoo as Fanuc, the G17 (G18 -G19) is given on a separate line then G68 X..Y... is center of rotation point followed by R rotation angle in + or - deg from 0 to 360. all moves after are rotated until G69. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
