Feed hold stops spindle

Results 1 to 5 of 5

Thread: Feed hold stops spindle

  1. #1
    Member positiverake's Avatar
    Join Date
    Sep 2005
    Location
    United States
    Posts
    267
    Downloads
    0
    Uploads
    0

    Default Feed hold stops spindle

    2004 doosan puma 240 fanuc 21i tb anybody know what keep relay I need to change so the spindle dont stop when using feed hold? thanks

    Similar Threads:


  2. #2
    Member dcoupar's Avatar
    Join Date
    Mar 2003
    Location
    USA
    Posts
    2932
    Downloads
    0
    Uploads
    0

    Default Re: Feed hold stops spindle

    I believe it's K3.0 (there should be a list of keep relay settings in the "blue book").

    From the operator's manual:

    K3.0 Set "0" Feed hold operates but spindle and coolant don't stop.
    Set "1" Feed hold operates and spindle & coolant stop.
    However, in case of executing fixing cycle for thread cutting
    or tapping, operation will be stopped after finishing
    actual machining part.



  3. #3
    Member positiverake's Avatar
    Join Date
    Sep 2005
    Location
    United States
    Posts
    267
    Downloads
    0
    Uploads
    0

    Default Re: Feed hold stops spindle

    Thanks dc you are rite on the money, works the way I want'ed it to, dont know why anybody would want the spindle to stop with a feed hold but anyway thanks again!



  4. #4
    Member dcoupar's Avatar
    Join Date
    Mar 2003
    Location
    USA
    Posts
    2932
    Downloads
    0
    Uploads
    0

    Default Re: Feed hold stops spindle

    You're quite welcome. I remember the first Doosan (Daewoo at that time) I ran, I thought, "How handy, I don't have to stop the spindle and coolant!" That feeling lasted about 2 minutes into proving out my first program. Then I thought, "What a PITA!"



  5. #5
    Member
    Join Date
    Jan 2010
    Location
    australia
    Posts
    321
    Downloads
    0
    Uploads
    0

    Default Re: Feed hold stops spindle

    I have a 8s and a 10hc. The 8s spindle stops the 10hc doesn't. I quite like that it stops. Great to clear a bird's nest or change an insert mid rough cut. Check clearance to the jaws in dry run.
    The worst part is if you open the chuck during this feed hold condition as soon as the chuck closes the spindle starts up. That is down right dangerous.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Feed hold stops spindle

Feed hold stops spindle