Need Help! Umbrella sticking on return after tool change

Results 1 to 2 of 2

Thread: Umbrella sticking on return after tool change

  1. #1
    Registered
    Join Date
    Jun 2017
    Location
    United States
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Umbrella sticking on return after tool change

    Hey folks, I could use a hand here. Occasionally, on our 2006 DMV 3016, the tool carousel/umbrella doesn't want to return home after a tool change. It goes slowly and then picks up speed or sometimes it doesn't even get going. You can give it a shove to get it going and then it returns. It may work well for a few cycles and then it sticks again. We have cleaned and lubed all the running surfaces and I am at a loss to explain it. It always comes forward with no issues. Ideas?

    Similar Threads:


  2. #2
    Member
    Join Date
    Sep 2007
    Location
    the netherlands
    Posts
    66
    Downloads
    4
    Uploads
    0

    Default Re: Umbrella sticking on return after tool change

    hi

    i have the same thing with my Myxs NM510.
    then when i push it up it does not want to go ,but if i try to pull it down it goes up in position .

    greeting bertus



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Umbrella sticking on return after tool change

Umbrella sticking on return after tool change