| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Controller & Computer Solutions Discuss computers and setups for cnc controllers. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-16-2008, 12:30 PM
| |||
| |||
I have a rotary table on this machine that I never use nor will I ever use on this particular machine, and it gives me fits on start ups by not homing out. I want to remove it from the machine and get rid of it. I'm assuming I unplug from a board. Do I then remove the board, and also I need to know if there is a parameter or setting in the control I need to shut off? I'm just not very familiar with these controls and all I use the machine for is drilling and tapping. Any help would be great!! Thanks    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem- HydraPath III & DNC | krema | Controller & Computer Solutions | 11 | 12-06-2010 05:52 AM |
| DNC Questions about MHP B-22 with Hydrapath III | Jim Estes | Machine Problems, Solutions , Wireless DNC, serial port | 18 | 12-28-2009 04:47 PM |
| the Difference of 2-Axis and 3-Axis of Vertical Mill Machine | begacon | Knee Vertical Mills | 6 | 07-30-2009 07:31 AM |
| Compare Catia and MCX2 for multi axis lathe/4 axis mill | bob1112 | General CAM Discussion | 0 | 10-10-2008 08:15 PM |
| New Design - Hybrid 3-Axis Router/4-axis Foam Hot Wire Cutter | the__extreme | CNC Wood Router Project Log | 3 | 02-26-2007 03:58 PM |
| | |
Linear Mode
