| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Controller & Computer Solutions Discuss computers and setups for cnc controllers. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-14-2008, 02:37 AM
| |||
| |||
HI EVERYBODY!!! I have 3 mashine tools -EGAR320,Egar 320Ò and glass table with NUM 1040(also Z.Bavellony) PROBLEM with EGAR320: after reprogramming EGAR320 I have a mistake at a capture of the tool a spindle approximately in 1-2 degrees.The Tool is incorrectly established in a spindle. HOW to solve this trouble (with software îr Hardware)? For reprograming i am use NUMTOOLS WORKSHOP and files beckap my EGAR 320 from Bavellony Best regards ! Russia Sochi PUTEVI Burula Oleg(lead.eng) gsm@sochi.net    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
