Acamatic 2100 problem - CNCzone.com-The Largest Machinist Community on the net!

Julian M · #1 08-31-2008, 09:25 AM

Hello everyone,

I have a SMV1000 with a acamatic 2100 control, when i turned the machine on this morning, the lights on the er/lt modules flash on but instantly the machine losses power and trips out the switch on our distribution box.
Any ideas would be appreciated.

THANKS

advt001 · #2 08-31-2008, 10:06 AM

I have had a similar situation with a bad power supply.

Julian M · #3 08-31-2008, 10:14 AM

Originally Posted by advt001

I have had a similar situation with a bad power supply.

I have a spare PSU, so i wil try replacing it. Thankyou

Julian M · #4 08-31-2008, 12:03 PM

Originally Posted by advt001

I have had a similar situation with a bad power supply.

I tried replacing the PSU but it still trips out. We have just instaled this
machine and was wondering if it could be the rating of the trip switch.We are
using a 16Amp fuse.Does anyone have any advise on which rating fuse we should be using?

Julian M · #5 09-10-2008, 11:58 AM

Found out i needed a 30Amp trip switch. Its working fine now.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Acramatic 2100	clayman	General Metalwork Discussion	1	02-18-2011 06:29 PM
acramatic 2100 questions	Clawsie Machine	General CNC (Mill and Lathe) Control Software (NC)	7	07-07-2010 10:20 PM
Acramatic 2100 hdd	Amtec	General CNC (Mill and Lathe) Control Software (NC)	10	02-18-2009 02:49 PM
Acramatic 2100/Cincinnati Lancer - Touch screen problem!	Per O.	Machine Problems, Solutions , Wireless DNC, serial port	10	02-08-2009 05:19 PM
Acramatic 2100 problem	mrfixit	Machine Problems, Solutions , Wireless DNC, serial port	1	05-22-2006 09:28 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)