| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Controller & Computer Solutions Discuss computers and setups for cnc controllers. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-29-2008, 03:15 PM
| |||
| |||
Hello, I am new at this site. I purchased a Spotseeker II XYZ motion table, which has a parallel port interface to its built in stepper motor interface. Is anyone aware the the command set to control the stepper? thanks in advance, Chris    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| add cnc controller | synv | SolidCam | 0 | 01-08-2008 10:07 AM |
| DeskCNC 2nd. gen controller AND HobbyCNC Pro Controller | maycom | DeskCNC Controller Board | 1 | 06-02-2007 02:33 PM |
| All in one controller | dwacker | DIY-CNC Router Table Machines | 12 | 04-14-2007 08:28 PM |
| New, H1 CNC Controller | icm | Product Announcements & Manufacturer News | 4 | 09-03-2006 05:56 AM |
| Looking 4 controller | hotroad | Hobbycnc (Products) | 2 | 12-06-2005 11:21 PM |
| | |
Linear Mode
